Front Suspension

On the front of the buggy start with .5 degrees of toe in, along with 2 degrees neg camber. You will want to run the front arms just below level. Use the outside hole on the steering linkage. For camber locations use B and 3 on the front. For the front shocks start with 25 weight oil with 770 pistons and blue springs with a .060 limiter in the shock. As for shock location use hole two on the tower and the middle hole on the arm. Reverse the spindles on the car.

Rear Suspension

Run 2 degree pivot support along with 2 degrees neg. camber. Run the dogbones just below level. Mount the shocks in hole two on the tower and the outside hole on the arm. For the shocks use 30 weight oil with 566 pistons and pink springs, use a .090 limter on the inside of the shock and an A spacer on the outside of the shock. The camber locations on the rear will be hole 5 and hole B. Run the rear hubs in the center position.

Transmission and Chassis

Front Tire use a Losi Wide Body (S> for the rear use a Losi IFMAR Pin (S). Battery located 3/8 inch back. Use a Hydra with standard fluid.