Front Suspension

On the front of the truck start with .5 degrees of toe in, along with 2 degrees neg camber. You will want to run the front arms level. Use the outside hole on the steering linkage. Use three gold washers under the camber ball. Use the inner hole on the shock tower for the other camber location. For the front shocks start with 30 weight oil with 556 pistons and pink springs with a .060 limiter in the shock. As for shock location use hole two on the tower and the middle hole on the arm.

Rear Suspension

Run 2 degree pivot support along with 2 degrees neg. camber. Run the dogbones just below level. Place the shock tower in the lower position and mount the shocks in hole two on the tower and the middle hole on the arm. For the shocks use 30 weight oil with 566 pistons and yellow springs, use a b spacer on the outside of the shock and .030 limiter on the inside. The camber locations on the rear will be hole 6 and hole A. Run the rear hubs in the center position.

Transmission and Chassis

Front Tire use a Losi Directional (S) Rib in for the rear usea Losi IFMAR Pin (S). Use the X-Long chassis with the batery located 5/8 inch back.